Existing
hole
Existing
screw
Existing screw
Existing
hole
fig. 3
120
Existing
hole
Existing hole
Assembly diagram fig. 3
The tow hook structure must be fastened
at the points marked by Ø using a total
of 6 M10 screws.
The internal back plates should be at least
6 mm thick.
The hook should be fastened to the body
avoiding any type of drilling of the rear
bumper that remains visible when the
hook is removed.
IMPORTANT It is compulsory to attach
a label (plainly visible) of suitable size and
material at the same level as the hitch ball,
with the following wording:
MAX LOAD ON BALL 60 kg
WARNING
After assembly, the screw
holes should be sealed to
prevent exhaust gases getting in.
F0M0143m