Troubleshooting - Greenlee EK50ML Instruction Manual

Troubleshooting

Before You Begin
1. Make sure that the battery is charged. Recheck
the battery after several minutes to make sure the
battery is holding its charge.
Problem
Tool is inoperative.
Motor is inoperative.
LED glows for 20 seconds.
Note: For Warranty Service or Repair, contact Greenlee customer service at 800-435-0786.
Greenlee / A Textron Company
EK50ML Battery-powered Crimping Tool
Possible Cause
Continuous use causes tool to become
too hot and automatically switch off.
Dirt, contaminants, etc., in jaw area
of tool.
Tool components worn or damaged.
Low or uncharged battery.
Broken switch components.
Battery charge low.
2. Use a nonflammable contact cleaner or pencil
eraser to clean the electrical contacts on the battery
and tool.
3. Reinstall the battery and check the tool again.
Probable Remedy
Allow approximately 3 to 5 minutes of
time to cool down.
Clean tool.
Return tool to a Greenlee Authorized
Service Center.
Try known charged battery. Inoperative
battery may be discharged or may have
reached life expectancy.
Return tool to a Greenlee Authorized
Service Center.
Charge or replace battery.
10
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070