6,401,515, 6,718,870, 7,086,979, and 7,254,982. All specifications are nominal and may change as design improvements occur. Greenlee Textron Inc. shall not be liable for damages resulting from misapplication or misuse of its products. GATOR is a registered trademark of Textron Innovations Inc.
This tool is not insulated. When using this unit near energized electrical lines, use proper personal protective equipment. Failure to observe this warning could result in severe injury or death. Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070...
Failure to observe these precautions may result in injury or property damage. Note: Keep all decals clean and legible, and replace when necessary. Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070...
2. Retract Button 7. Trigger 3. LED Indicator (red) 8. Cutting blades (ETS8L and ETS12L) 4. Battery Lock 9. Lanyard Ring (ETS8L) 5. Battery Cartridge Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070...
18 V, 1.5 Ah lithium-ion battery 52049202 230 VAC, 18 V charger 52049189 18 V, 3.0 Ah lithium-ion battery 52049204 12 VDC, 18 V charger Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070...
Motor current exceeds Tool will stop, and flashing 20 A during cycle light for 20 seconds when trigger is released Circuit has become too hot Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070...
Page 9
Note: The cutting process can be interrupted at any moment by releasing the trigger. By actuating the retract slide, the piston and movable blade will return to the starting position. Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070...
Do not leave a sharp edge. surface. This will cause chipping of cutting surface and will Figure A decrease blade life. Flatten this surface. Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070...
2. Check the oil level. grene, or death. Annually or After 10,000 Cuts 1. Replace the hydraulic oil. 2. Send the tool to a Greenlee Authorized Service Center for inspection. Do not use solvents or flammable Checking the Oil Level liquids to clean the tool body.
Tool loses oil. Damaged internal seal. Return tool to a Greenlee Authorized Service Center. Note: For Warranty Service or Repair, contact Greenlee customer service at 800-435-0786. 4455 Boeing Drive • Rockford, IL 61109-2988 • USA • 815-397-7070 USA Tel: 800-435-0786...