Appendix C: Peripheral Unit Drive Circuit - Star SP200F SERIES User Manual

Appendix C: Peripheral Unit Drive Circuit

A drive circuit for driving peripheral units (such as cash drawers) is featured on
the main logic board of this printer. A modular connector for driving peripheral
unit is featured on the output side on the drive circuit. When using this circuit,
connect the cable for the peripheral unit. (Cables must be prepared by the user.)
Note: Peripheral unit drive circuit connector only connects to peripheral units
such as cash drawers, etc.
Do not connect it to a telephone.
Use cables which meet the following specifications.
Modular plug
Separated Ground wire
connected to shield
(Europe only).
1 Connecting the cable
Separated
Ground wire
Connector for the
peripheral unit drive circuit
SERIAL INTERFACE
Separated ground wire is required for Europe only.
Shield
Wire lead
Note: Pin 1 must be shield drain wire connected to
peripheral device frame ground.
Fig. C-1 Cable specifications
Cable
Screw
M3x5
Fig. C-2 Connecting the cable
Manufacturer
MOLEX
AMP
JAPAN BURNDY
Separated
Ground wire
Connector for the
peripheral unit drive circuit
PARALLEL INTERFACE
– 95 –
Model
90075-0007
641337
B-66-4
Cable
Screw
M3x5