Star SP200F SERIES User Manual page 11

Roll paper
Fig. 4-5 Loading the paper
Positioning rib
Paper roll holder
Fig. 4-6
2 Cut off the front edge of the roll
3 Confirm that the power of the printer
4 While observing the direction of the
Core
Axis
5 Move the paper roll holder in the
Paper roll holder
6 If the paper roll core has not been
7 Press the FEED (paper feed) switch to
8 Insert the top edge of the paper into
Cover
Roll paper
– 8 –
paper perpendicularly.
is turned on.
roll paper, insert the top end of the
paper beneath the paper guide as far as
it will go. If the roll paper is installed,
the top end of the paper automatically
comes out from the paper exit.
direction of the arrow, and insert the
roll so that the holes in the core align
with the axes of the paper roll holder.
Release the paper roll holder to se-
cure the paper.
properly aligned with the paper roll
holder, the cover cannot to properly
seated until the paper position is
corrected.
feed the paper approximately 10cm.
the tear bar slot, then mount the cover
by reversing the procedure for re-
moving the cover in step 1 above.
Note: When the paper end mark ap-
pears on the paper, replace the
roll paper before it runs out.
Tear bar
FEED switch
Fig. 4-7