Adjusting The Sound - JVC KD-AR390 Instructions Manual

VOLUME 00 to 50 or
Adjust the volume. 00 to 30*5
*1
Ifyou are using atwo-speakersystem, set the fader
level to "00."
*2
This adjustment will notaffea the subwoofer output.
*3
Loudness setting will be applied to allsound modes.
*4
Displayed only when "Va MODE"is set to "SUB. W"
(see page 23).
*5
Depending on the amplifier gain control setting. (See
page
23
for details.)
Sound
Range/selectable items
elements
BASS MID TRE
Frequency
60Hz 500 Hz 7.5 kHz
80 Hz 1.0 kHz 10.0 kHz
100Hz 1.5 kHz 12.5 kHz
120Hz 2.5 kHz 15.0 kHz
Level (LVL) -06 to -06 to -06 to
+06 +06 +06
0
00.5 00.75 00.75
01.0 01.0 01.25
01.5 01.25
02.0 01.5
BASS: Bass MID: Mid-range TRE: Treble
5
Repeat steps 3and 4to adjust other sound
characteristics.
The adjustment made will be stored automatically.
Adjusting the sound
You can adjust the sound characteristics to your
preference.
• The adjustment you make will be stored for the
currently selected sound mode (iEO) including
"USER."
1
~
[FADER - BALANCE - LOUD
J
. . " . VOLUME - VOL ADJ - SUB.W
2
[Turn]
FADER*1
Adjust the front and rear speaker
output balance.
BALANCE*2
Adjust the left and right speaker
output balance.
LOUD*3 (loudness)
Boost low and high frequencies to
produce awell-balanced sound at a
low volume level.
SUB.W*4 (subwoofer)
Adjust the subwoofer output level.
VOL ADJ (volume adjust)
Adjust the volume level of each source
(except FM), compared to the FM
volume level. The volume level will
automatically increase or decrease
when you change the source.
• Before making an adjustment,
select the source you want to adjUSt.
R06to F06
L06 to R06
LOUD ON or
LOUD OFF
00 to 08,
initial: 04
-05 to +05,
initial: 00
SETIINGS 21