Table of Contents
Advertisement
SOUND ADJUSTMENTS
Turning on/off the loudness
function
The human ear is less sensitive to low and high
frequencies at low volumes.
The loudness function can boost these
frequencies to produce a well-balanced sound at
low volume levels.
Each time you press LOUD, the loudness
function turns on/off alternatively.
Adjusting the sound
You can adjust the sound characteristics to your
preference.
1
Select the item you want to adjust.
BAS
(bass)
VOL
(volume)
Indication
To do:
BAS
Adjust the bass.
TRE
Adjust the treble.
FAD*
Adjust the front
and rear speaker
balance.
BAL
Adjust the left
and right speaker
balance.
VOL
Adjust the volume.
* If you are using a two-speaker system, set the fader
12
Each time you press the
button, the adjustable items
change as follows:
TRE
FAD
(treble)
(fader)
BAL
(balance)
Range
–06 (min.)
|
+06 (max.)
–06 (min.)
|
+06 (max.)
R06 (Rear only)
|
F06 (Front only)
L06 (Left only)
|
R06 (Right only)
00 (min.)
|
50 (max.)
2
Adjust the level.
Equalization pattern changes as you adjust the
bass or treble.
Note:
Normally the control dial works for volume
adjustment. So you do not have to select "VOL"
to adjust the volume level.
Using the Sound Control
Memory
You can select and store a preset sound
adjustment suitable for each playback source.
(Advanced SCM)
Selecting and storing the sound modes
Once you select a sound mode, it is stored in
memory. It will be recalled every time you select
the same source and will be shown on the
display.
A sound mode can be stored for each of the
following sources — FM1, FM2, FM3, AM and CD.
• If you do not want to store the sound mode
separately for each playback source, but want
to use the same sound mode for all the
sources, see "To cancel Advanced SCM – SCM
LINK" on page 15.
Select the sound mode you want.
Each time you press the button, the
sound mode changes as follows:
BEAT
SOFT
To increase the level.
To decrease the level.
POP
SCM OFF
Advertisement
Table of Contents
