Maintenance; Fitting A New Spool Of Cutting Line - Qualcast GT2518 Instruction Manual

Maintenance

You tool has been designed to operate over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool care and regular cleaning.
WARNING! Before performing any maintenance, switch off and unplug the tool.
Regularly clean the ventilation slot in your tool using a soft brush or dry cloth.
Regularly clean the cutting line and spool using a soft brush or dry cloth.
Regularly use a blunt scraper to remove grass and dirt from the underneath of the guard.

Fitting a New Spool of Cutting Line

7
Unplug the tool
• Depress the tab on the side of the spool cover and remove the spool cover
.Remove the empty spool
• Remove any dirt and grass from the spool cover and housing. Insert the new spool and push It into
the boss in the housing.
• Unclip the end of cutting line
protrude approx. 10cm from the housing.
• Align the tabs on the spool cover with the outlets in the housing.
Push the cover onto the housing until it snaps securely into place.
WARNING! If a cutting line protrudes beyond the trimming blade, cut it off so that it just reaches the
blade.
12
8
1
2
4
3
2 from the housing.
4 and guide the line into the eyelets in the housing. The line should
Customer Helpline 08456 400 800
1
2
4
3
1 from the housing 3