Winding New Line Onto A Spool - Qualcast GT2518 Instruction Manual

Maintenance

Winding New Line onto a Spool

9
• You may wind new cutting line onto an empty spool. Use 1.5mm line
•
Remove the empty spool from the tool as described above.
• Remove any remaining cutting line from the spool.
• First feed 10 cm of cutting line
the spool as shown, the other eyelet in the lower section not shown, but still proceeding in the same
manner as shown for the upper section.
• Wind the cutting line onto the spool in the direction of the arrow
neatly and in layers. Do not criss-cross.
• Lock the cutting line into a slot on the edge of spool.
• Insert the spool into the cutter head assembly as described above. Do not forget to release the cutting
line from the slot on the edge of the spool and tread it through the eylets in the housing (see- Fitting a
New Spool).
WARNING! Only use the appropriate type of cutting line.
5
4
4 into each of the two eyelets, one eyelet
Customer Helpline 08456 400 800
10
6 . Make sure to wind the line on
6
5 in the upper section of
13