Reset To Factory Defaults; Motor Timing - Dynamic Perception MX3 User Manual

7. [Enter] to save the parameter value
Setting LCD AutoOff Sec. to zero disables the automatic turning off of the backlight.

11.2. Reset to Factory Defaults

Should the need arise, you can reset all stored parameters saved to permanent memory inside
of the MX3. Once activated, you can abort this action within 8 seconds by pressing enter. After
memory has been reset, you will be unable to use the MX3 until you power cycle the device. The
screen will inform you of this.
Menu Navigation:
1. [Enter] to enter the Main System Menu
2. [Up] or [Down] until Settings is selected
3. [Enter] to enter Settings menu
4. [Up] or [Down] until Reset Memory is selected
5. [Enter] to execute the Reset Memory action
6. [Enter] within 8 seconds to cancel, or
7. Power-cycle the MX3 after the reset is complete

11.3. Motor Timing

The motor timing parameter controls the minimum length of pulses sent to the motor in
microseconds. You should not need to change this parameter, unless it is not possible to
achieve even medium speeds with your given motor. Increasing this parameter results in longer
on and off pulses, and therefore "rougher" motion, and decreasing it results in "smoother"
motion, but less power at low speeds.
Menu Navigation:
1. [Enter] to enter the Main System Menu
2. [Up] or [Down] until Settings is selected
3. [Enter] to enter Settings menu
4. [Up] or [Down] until Motor Timing is selected
5. [Enter] to edit the Motor Timing parameter
6. [Up] or [Down] to change the parameter value
7. [Enter] to save the parameter value
All Contents licensed under the Creative Commons Attribution Share-Alike 3.0 License
Page 42 of 45
Copyright © 2013 Dynamic Perception LLC
dynamicperception.com