Main Control Screens; Program Control - Dynamic Perception MX3 User Manual

4. Main Control Screens

The majority of your interaction with the MX3 will be through the main control screens, each of
these screens gives access to a number of parameters related to that screen. To change
control screens, simply press
available screens.

4.1. Program Control

The Program Control screen controls the basic operation of the program, which executes your
time-lapse film. On this screen, we have control over whether the program is running (Off, or
On), the camera interval (in tenths of seconds), and the motion mode (Continuous or
Shoot-Move-Shoot). Additionally, the run time in hours, minutes, and seconds is displayed on
this screen.
For more information on Continuous and Shoot-Move-Shoot, see the Motion Control section below
You may start or stop the program at any time through the on/off control, and may
change the interval control while the program is running. However, you may onl
change the motion mode when the program is stopped.
[Up] or [Down] while no control is selected to cycle through the
All Contents licensed under the Creative Commons Attribution Share-Alike 3.0 License
Page 11 of 45
Copyright © 2013 Dynamic Perception LLC
dynamicperception.com
.