Cold Weather Modification - Dynamic Perception MX3 User Manual

10. Cold Weather Modification

The MX3 has an available Cold Weather Mod that expands its operating low temperature rating
to -20C (-4F). This involves, amongst other activities, replacing the LCD screen with one which
is self-heating. As the LCD heater can consume electricity, the cold weather modification can
be disabled when not shooting in very cold environments.
To enable or disable the cold weather mod, you'll need to set the correct value in the Cold Mode
parameter inside of the settings menu.
Menu Navigation:
1. [Enter] to enter the Main System Menu
2. [Up] or [Down] until Settings is selected
3. [Enter] to enter Settings menu
4. [Up] or [Down] until Cold Mode is selected
5. [Enter] to edit the Cold Mode parameter
6. [Up] or [Down] to change the parameter value
7. [Enter] to save the parameter value
The cold weather mod may reduce screen visibility in bright light or when the
backlight is off.
Altering the cold mode parameter is only effective if the cold weather mod is installed
The cold weather mod should only be installed by authorized Dynamic Perception
service persons. Attempting to self-install a cold weather mod may damage your
MX3 and void your warranty.
All Contents licensed under the Creative Commons Attribution Share-Alike 3.0 License
Page 40 of 45
Copyright © 2013 Dynamic Perception LLC
dynamicperception.com