Linear Ramping - Dynamic Perception MX3 User Manual

then use [Right] or [Left]
value.
Lead-in/out and ramp controls work together, if both are used, then a lead-in will
occur before the ramp-in starts.
A lead-out is only performed if the Maximum Shots setting is set for the camera,
otherwise the MX3 will not know when to start a lead-out.
Changing the lead control while the program is running will only affect the lead-out.

7.6. Linear Ramping

The MX3 can automatically apply linear ramping to each move. In the case of linear ramping, the
motor will be brought from 0 speed to the specified speed over the requested number of
exposures. This allows for smooth starts and stops.
Changing the ramp control while a program is running and the motor control is On
will only affect the ramp out.
You can start a motor ramping in at any time during the film by leaving the motor
control off when starting the program, and then manually turning the motor control to
on when you're ready to start moving.
to move to the Lead Control. Now, use
Lead Set to 15 Exposures
All Contents licensed under the Creative Commons Attribution Share-Alike 3.0 License
[Up] and [Down] to adjust the
Page 27 of 45
Copyright © 2013 Dynamic Perception LLC
dynamicperception.com