Startup; Engine Shut-Down - Beta ALP 200 Handbook

STARTUP

Set the fuel tank tap to ON or RES (see page 18).
- Position the key to
(see page 21).
- Check that the gears are in neutral (page 20).
- Pull the clutch lever (page 18).
WARNING!
If you do not pull the clutch lever the vehicle will not start.
- Retract the stand (page 20).
WARNING!
If the stand is not retracted, the engine will stall when the gears are engaged.
KICKSTART (page 20):
Depress the kick-starter with a sharp movement of the foot.
ATTENTION!
Once the pedal has been depressed, release it immediately. This avoids jolts to the
entire ignition group and to the foot.
ELECTRIC START (page 18):
Push the button until the engine starts. Do not press the button while the engine is
running.
COLD STARTING:
Turn on the starter (page 19), when the engine is cold, start the vehicle, wait a
few minutes, then move the starter back to its starting position.

ENGINE SHUT-DOWN

To shut-down the engine, proceed in one of the two following ways:
- turn the key to
- press the button
NOTE:
With the engine stopped, always set the fuel tap to OFF (page 18).
(see page 21).
on the switch unit (see page 19).
29
2
GB