Table of Contents
Advertisement
2. Disconnect the connectors (1, 2, 3, 4, and 5) from the controller board (6). See the chart
below for connector locations.
3. Turn the printer over. Unscrew the Phillips screw (7) holding the controller board (6) to
the inner housing (8).
4. Remove two screws (11) and two washers (12) from the front of the printer before trying
to separate the controller board (6) from the inner housing (8).
Notes on replacing the controller board assembly
(9-pin communication connector only):
When replacing the controller board (6), remove the board spacer (9) from the old
board and attach it to the new controller board. The spacer is held on the controller
board by one Phillips screw (10).
Connector/Harness
Ribbon Cable Assembly
Paper Feed Stepper Motor Cable
Switch and LED Assembly Harness
Switch Wire Harness
Cutter Stepper Motor Cable
Assembly/Disassembly
Controller Board Location
J9
J5
J6
J1
J4
Advertisement
Table of Contents
