Oki OKIPOS 80 Plus III Maintenance Manual page 34

  " "   

Maintenance Manual
1. Remove the cover assembly. (See page 26).
2. Turn the printer over.
3. Unscrew the four Phillips screws (1) holding the inner housing (2) to the outer housing
(3).
4. Lift the printer's inner housing (2) straight out of the outer housing (3).
Note on replacing the outer housing
If you are replacing the outer housing (3), place two new rubber feet bumpers (4) into
the two inserts located on the bottom near the front of the printer. Also, replace the
serial number label (5).