Print Head - Oki OKIPOS 80 Plus III Maintenance Manual

  " "   

Maintenance Manual
1. Remove the outer housing. (See page 27).
2. Flip the printer upside down and remove the bottom screw (1 on page 32 view).
3. From the front, remove the two screws (2 on page 32 view) and two washers (3 on page
32 view). The ESD shield should easily come off.
4. Remove the ribbon cable assembly (6 on page 32 view).
5. Remove the two head retaining screws (1 on page 33 view).
6. Open the cover, and lower the thermal print head (2 on page 33 view) and paper guide (3
on page 33 view) from the bottom of the printer.
Note on installing the thermal print head
When installing the thermal print head (2 on page 33 view), be sure to properly align
the two print head alignment slots with the holes in the printer before installing the
two head retaining screws (1 on page 33 view).