Using The Dvc-1000; Status Icons - D-Link i2eye DVC-1000 Manual

Using the DVC-1000

Main
Window
Status
Message
Area
Banner
Window
After the DVC-1000 VideoPhone is setup by using the Setup Wizard, you will
see the above Main Screen each time you turn on the VideoPhone. There is a
larger Main Window that displays the self-view until a call is connected and
then displays the party you are calling. The smaller Self-View Window then
displays the self-view when a call is connected. To flip the images that are in
the Main Window and Self-View Window press the Self/Remote button on
the remote control.

Status Icons

The Status Icons appear only briefly at startup. The DVC-1000 uses icons to
indicate its status. The icons display on the top right side of the Main Screen. If
an icon is displayed, this indicates the operation is not complete. The icon will
disappear after the operation completes. If the icon appears with a yellow "X"
through it, this means the operation was unsuccessful. If the Directory Service
status icon is displayed with an "X" through it, you can still make VideoPhone
calls by inputting the IP address of the phone that you are calling. (See Entering
IP addresses on page 22.) This is a list of the status icons:
Looking for i2eye updates
Obtaining the Public IP address (Router's Address)
DVC-1000 is registering with the Directory Service
Layout of the i2eye Main Screen
Ready for call
Status
Icons
Main
Settings
Buttons
Privacy
Status
Icons
Self-View
Window
14