Using A Telephone With The Dvc-1100 - D-Link DVC-1100 Manual

Using the Setup Wizard (continued)
System Restart
A message appears asking
to restart the DVC-1100 to
complete the setup. Press
the Yes button to perform
a restart and complete the
Setup Wizard.
Congratulations! You are now ready to make and
receive i2eye VideoPhone calls.

Using a Telephone with the DVC-1100

Although optional, it is recommended that you connect a standard telephone to
the DVC-1100 VideoPhone.
The telephone that you use for the DVC-1100 VideoPhone will not
be connected to your phone wall jack. You will use the telephone as
a means of conducting and receiving calls over the Internet only.
The telephone handset is used to place video calls over the Internet, similar to
how you would with a regular phone call. You dial a VideoPhone number to
reach a party on the other end of the VideoPhone call. You can speak through
the telephone, listen to the other party in privacy, and even switch to the
Speakerphone Mode on the DVC-1100 to share the audio with others. This
can all be controlled by the remote control. When the phone is picked up, the
built-in and external microphones are muted. When you receive a VideoPhone
call, the telephone rings.
You can use a cordless phone, a telephone with a speakerphone to replace the
built-in microphone to share the call with others and even use a phone recorder
to allow recording of an audio message when someone calls your VideoPhone
and you are not available.
The DVC-1100 supports dialing methods throughout the world. Please refer to
page 25 for details on how to dial local video calls, calls outside of your Area
code and calls outside of your Country code.
18