Table of Contents
Advertisement
that you leave this item at the default value.
DRAM Burst Len (4)
This item describes which burst lengths are supported by the devices on the
mainboard.
Write Recovery Time (3T)
This item controls the timing between write and precharge command.
Press <Esc> to return to the Advanced Chipset Features screen.
AGP & P2P Bridge Control
Scroll to this item and press <Enter> to view the following screen:
Phoenix – AwardBIOS CMOS Setup Utility
AGP Aperture Size
AGP Mode
AGP Driving Control
x
AGP Driving Value
AGP Fast Write
AGP Master 1 WS Write
AGP Master 1 WS Read
DBI Output for AGP Trans
↑ ↓ → ← : Move Enter: Select
F5:Previous Values
AGP Aperture Size (128 MB)
This item defines the size of the aperture if you use an AGP graphics adapter.
The AGP aperture refers to a section of the PCI memory address range used
for graphics memory. We recommend that you leave this item at the default
value.
AGP Mode (4X)
This item allows you to enable or disable the caching of display data for the
processor video memory. Enabling AGP-4X Mode can greatly improve the
display speed. Disable this item if your graphics display card does not support
this feature.
AGP Driving Control (Auto)
This item is used to signal driving current on AGP cards to auto or manual.
Some AGP cards need stronger than normal driving current in order to
operate. We recommend that you set this item to the default.
•
AGP Driving Value: When AGP Driving Control is set to
Manual, use this item to set the AGP current driving value.
AGP & P2P Bridge Control
[128M]
[4X]
[Auto]
DA
[Disabled]
[Disabled]
[Disabled]
[Disabled]
+/-/PU/PD: Value:
F10: Save ESC: Exit
F6:Fail-Safe Defaults
35
Item Help
Menu Level
F1:General Help
F7:Optimized Defaults
Advertisement
Table of Contents
