Backup Setting Data; Restore Setting; Delete Panorama Image - Sony SNC-WR630 User Manual

When you click OK, the network indicator on the
camera starts to blink. After adjustments of the default
settings have finished, the camera reboots automatically.
Do not turn off the camera until the camera reboots.
Tip
The camera can also be reset to the factory settings by
turning on the power of this unit while pressing the reset
button on the camera. For details, refer to the supplied
Installation Manual.
Format memory card
You can format a memory card (not supplied) inserted
into the card slot of the camera. When you click
Format, a confirming message appears. Click OK to
start formatting. Any files and folders stored in the
memory card will be deleted.
Notes
• Before formatting, set Edge Storage movie and Edge
Storage still image in the Execution Condition tab of
the Action output menu to Off, to write-protect the
memory card.
• Do not activate the Format memory card function
when no card is inserted into the card slot.

Backup setting data

Saves the setting data of the camera in a file.
Click Save, and follow the instructions on the Web
browser to specify the folder and save the setting data of
the camera.
The file name preset at the factory is "snc-wr630.cfg"
for SNC-WR630.

Restore setting

Loads the stored setting data of the camera.
Click Browse... and select the file in which the setting
data is stored. Click OK, and the camera is adjusted
according to the loaded data.
Restore preset position and privacy masking
settings
If you select this, the stored setting data of the camera,
the preset position data and privacy masking data are
loaded.
Notes
• With Restore setting, some items in the Network
menu (page 31) cannot be restored.
• The following items cannot be stored or restored with
Backup setting data or Restore setting.
– audio files uploaded using SNC audio upload tool
– a panorama image recorded in the camera using
Panorama Creator of SNC toolbox
– a certificate to be used in the 802.1X function
– a certificate to be used in the SSL function
– thumbnail
– superimpose logo
Video & PT drive refresh
Image distortion and misalignment of the pan/tilt
position may occur during extended periods of use. Use
this function to correct image distortion and pan/tilt
misalignment. Video & PT drive refresh takes about 20
seconds to complete. Pan/tilt operations for the camera
are performed automatically during the refresh
operation. After refresh is completed, the pan/tilt
position returns to that at the start of the refresh
operation.
Enable
Check to use the refresh operation.
Manual
Click Execute to perform the refresh operation.
Schedule
Set time and date to perform the refresh operation
periodically.
Notes
• Camera operation will be canceled when you run
video & PT drive refresh while operating the camera.
• Position/shadow tours stops if video & PT drive
refresh is running while you are running position/
shadow tours.
After video & PT drive refresh has been completed,
the position/shadow tour restarts.
• The intelligent motion detection or camera tampering
detection stops immediately if you execute video &
PT drive refresh when the intelligent motion detection
or camera tampering detection is set.
After video & PT drive refresh is completed, the
motion detection or camera tampering detection
restarts.

Delete panorama image

Click Delete to delete panorama images set on this
camera.
Delete voice alert file
Click Delete to delete all the audio files stored in the
camera using SNC audio upload tool.
Notes
• Clicking Delete deletes all the stored audio files
simultaneously. To delete a specified audio file only,
perform deletion of the audio file in the corresponding
Configuring the System — System Menu
23