Initialize Tab; Restore Setting; Factory Default; Delete Custom Homepage - Sony Ipela SNC-CH140 User Manual

– Maximum detection size of VMF: to be width of
1280 and height of 720 when set to 1280 × 720 or
1280 and height of 1024 when set to 1280 × 1024.
Video out
You can configure the output setting for the analog
image output terminal of the camera. Select On to
output an NTSC or PAL signal.
Note
The output signal format is determined according to the
setting of the camera's NTSC/PAL switch.
OK/Cancel
See "Buttons common to every menu" on page 26.

Initialize Tab

Reboot
Used when rebooting the system.
Click Reboot, and the message "This System will be
rebooted. Are you sure?" appears. Click OK to reboot
the camera. It takes about two minutes to restart.

Factory default

Resets the camera to the factory settings.
Retain current network settings
When this item is checked, only the current network
settings will be retained after reset.
Click Factory default, and the message "Setup data will
be initialized. Are you sure?" appears. When you click
OK, the network indicator on the camera starts to blink.
After adjustments of the default settings have finished,
the camera reboots automatically. Do not turn off the
camera until the camera reboots.
Tip
The camera can also be reset to the factory settings by
turning on the power of this unit while pressing the reset
button on the camera. For details, see the supplied
Installation Manual.

Backup setting data

Saves the setting data of the camera in a file.
Click Save, and follow the instructions on the Web
browser to specify the folder and save the setting data of
the camera. The file name preset at the factory is "snc-
ch140.cfg" for SNC-CH140.
30
Configuring the System — System Menu

Restore setting

Loads the stored setting data of the camera.
Click Browse and select the file in which the setting data
is stored. Click OK, and the camera is adjusted
according to the loaded data, and restarted.
Notes
• With Restore setting, some items in the Network
menu (page 38) cannot be restored.
• The following items cannot be stored or restored with
Backup setting data or Restore setting.
– audio files uploaded using SNC audio upload tool
– a homepage created using Custom Homepage of
SNC toolbox
– a client certificate and CA certificate to be used in
the 802.1X authentication function
– Header logo
– superimpose logo
Format CF memory card (SNC-CH140
only)
Click Format to format the CF memory card (not
supplied) inserted into the CF card slot of the camera.
The files and folders stored in the CF memory card are
deleted while formatting.
Notes
• Before formatting, disable the image memory
function and FTP server function to protect the CF
memory card from writing.
• Do not activate the Format CF memory card
function when no card is inserted into the CF card slot.

Delete custom homepage

Click Delete to delete the homepages recorded in the
flash memory of the camera with Custom Homepage of
SNC toolbox (page 88).

Delete voice alert file

Click Delete to delete all the audio files stored in the
camera using SNC audio upload tool (page 93).
Notes
• Clicking Delete deletes all the stored audio files
simultaneously. To delete a specified audio file only,
perform deletion of the audio file in the corresponding
Voice alert tab of the Voice alert menu (page 69).
• Before deleting the audio file, set Voice alert to Off in
each tab of the Voice alert menu (page 69).
Delete header logo
Click Delete to delete the header logo set in the Viewer
menu.