- If a roll is loaded, be sure to remove the roll before this procedure. Remove the Roll Holder from the Auto Roll Feed Unit. Fasten a paper band or the like around

the paper to prevent the roll from unwinding.

(1) Move the Stand into position and lock the front casters.

(2) While holding the Carrying handles on both sides, align

(3) Secure the printer to the stand by firmly tightening the two Printer Securing Bolts [2] on both sides with the Allen Wrench [1] from under the Output Stacker

(four bolts in all).

F-3-51

F-3-52

F-3-53

on the back of the printer with

F-3-54

of the Output Stacker as you set the printer down on the Stand.

Chapter 3

3-15

Table of Contents