Canon iPF600 series Service Manual page 132

Chapter 3
(6) Open the top cover, raise the carriage shaft belt stopper [1], and then pull it forward to remove.
MEMO:
- You will need the Belt Stopper if you move the printer to another location. Do not discard the Belt Stopper you have removed.
- When you open the Top Cover, you will find a Cleaning Brush [3] on the right side. Use this brush to clean inside the Top Cover.
(7) Plug the power cord into the Power Socket on the back of the printer.
(8) Connect the power cord to the outlet.
(9) Set the printhead.
Press the Power botton to power on the printer.
(10) When the message "Open Top Cover" is displayed, open the top cover.
(11) Pull the printhead fixer lever forward to open it fully.
3-4
[2]
[1]
F-3-9
F-3-10
F-3-11
OK
F-3-12
F-3-13
F-3-14
[3]