Canon iPF600 series Service Manual page 50

Chapter 1
[Adjust Printer]
[Auto Head Adj.]
[Manual Head Adj]
[Auto Band Adj.]
[Manual Band Adj]
[Adj Far Ed Feed]
[Adjust Length]
[Adjust Head Skew]
[Interface Setup]
[EOP Timer]
[TCP/IP]
[NetWare]
[AppleTalk]
[Ethernet Driver]
[Ext.Interface]
[Init. Settings]
1-36
Setting Item
[Standard Adj.]
[Advanced Adj.]
[Auto Print]
[Standard Adj.]
[Advanced Adj.]
Setting Item
[TCP/IP]
[IP Mode]
[Protocol] [DHCP]
[BOOTP]
[RARP]
[IP Setting] [IP Address]
[Subnet Mask]
[Default G/W]
[NetWare]
[Frame Type]
[Print Service]
[Auto Detect]
[Comm.Mode]
[Ethernet Type]
[Spanning Tree]
[MAC Address]
T-1-18
Description, Instructions
Choose Yes to have the printer print and read a test pattern for the automatic
adjustment of Printhead alignment relative to the printing direction.
Choose Yes to have the printer print and read a test pattern for the automatic
adjustment of Printhead alignment relative to the nozzle, ink tank, and printing
direction.
Three sheets are required when printing on sheets.
Choose On to have the printer automatically execute the Advanced Adj. operations
after you replace the Printhead .
Choose Yes to print a test pattern for adjustment of Printhead alignment relative to
the printing direction. Enter the adjustment value manually based on the resulting
pattern.
Choose Yes to have the printer print and read a test pattern for band adjustment,
based on which the printer automatically adjusts the feed amount.
Choose this option when using paper other than genuine Canon paper, or paper for
purposes other than checking output.
Choose Yes to have the printer print and read a test pattern for band adjustment,
based on which the printer automatically adjusts the feed amount. Note that this
function takes more time and requires more ink than Standard Adj.
Two sheets are required when printing on sheets.
Choose Yes to print a test pattern for adjusting the feed amount based on the paper
type.
Two sheets are required when printing on sheets.
[Choose Yes to print a test pattern for adjusting the feed amount of the trailing edge
of paper based on the paper type.
Choose Yes to print a test pattern for adjustment relative to paper stretching or
shrinkage, after which you can enter the amount of adjustment.
Selecting [Yes] will print the pattern for adjusting the print head inclination.
T-1-19
Description, Instructions
Specify the timeout period for print jobs.
Specify the TCP/IP protocol settings. To apply your changes, choose Store
Setting .
Choose whether the printer IP address is configured automatically or a static IP
address is entered manually.
Specify the protocol used to configure the IP address automatically.
Specify the printer network information when using a static IP address.
Enter the IP address assigned to the printer, as well as the network subnet mask
and default gateway.
Specify the NetWare protocol. To apply your changes, choose Store Setting .
Specify the frame type to use.
Choose the print service.
Specify whether to use the AppleTalk protocol. To apply your changes, choose
Store Setting .
Specify the communication method. To apply your changes, choose Store
Setting .
Choose On for automatic configuration of the LAN communication protocol.
Choose Off to use settings values of Comm.Mode and Ethernet Type .
Choose the LAN communication method.
Choose the LAN transfer rate.
Choose whether spanning-tree packets are supported over the LAN.
Displays the MAC address.
When installing the expansion interface board, choose whether the expansion
interface board is used.
A confirmation message is displayed if you press the[
to restore the network settings to the default values.
] button. Choose [OK]