IBM eServer xSeries 440 Installation Manual page 46

Complete the following steps to cable your server to a remote I/O enclosure:
Cabling an SMP Expansion Module:
Expansion Module installed, complete the following steps.
RXE Management
Note: For information about cabling the RXE Management Ports see, "RXE
1. Using an RXE Expansion cable, connect one end of the cable to RXE Expansion
2. Connect the opposite end of the cable to an RXE Expansion Port on the remote
Cabling two SMP Expansion Modules:
Expansion Modules installed complete the following steps.
RXE Management
1. Using an RXE Expansion cable, connect one end of the cable to RXE Expansion
2. Connect the opposite end of the cable to an RXE Expansion Port on the remote
34
xSeries 440:Installation Guide
RXE Expansion Port (A)
RXE Management Port
A (in) Port
RXE Expansion Port
Management Port cabling" on page 35.
Port (A) on the server.
I/O enclosure.
RXE Expansion Port (B)
RXE Management Port
A (in) Port
RXE Expansion Port
Port (B) on the server.
I/O enclosure.
Note: When two SMP Expansion Modules are installed, both of the RXE
Expansion ports are active.
If your server has one SMP
xSeries 440
RXE-100
If your server has two SMP
xSeries 440
RXE-100