IBM eServer xSeries 440 Installation Manual page 36

10. Close the SMP Expansion Module top cover; then, install the module in the
11. If you have other options to install or remove, do so now.
12. Close the cover on the server; then, reinstall the server in the rack cabinet and
13. Turn on the server.
24
xSeries 440:Installation Guide
Captive screws
Protective cover
b. Align the heat sink over the microprocessor; then, carefully set it down on top
of the microprocessor.
c. Using a screwdriver, secure the heat sink to the microprocessor socket on the
SMP board using the two captive mounting screws. Press firmly on the
screws and tighten them, alternating between them. Do not overtighten the
screws.
server. For details, see "Reinstalling an SMP Expansion Module and cover" on
page 28.
connect all external cables. For details, see "Completing the installation" on page
31.
Important: If your server will not start after replacing or installing a
microprocessor, you might have installed a microprocessor of a different type or
the VRM is not installed properly. Verify that you have installed the proper
microprocessor and that the VRM is properly installed.
Note: When you install or remove microprocessors, the server configuration
information changes. Therefore, you must change and save the new
configuration information by using the Configuration/Setup Utility program.
See the User's Guide on the Documentation CD.
Heat sink