Instructions For Setting The Unit; Dts200B - Dzs200Bp 3/8/07 9:16 Am - Tork DTS200B Instruction Manual

DTS200B - DZS200BP 3/8/07 9:16 AM
Press ENTER. Schedule settings will be copied to the
current Memory Module, display will show:
Press ENTER. The display will show:
To copy another Memory Module, take the existing one
out, insert the next module to be copied and press the
EVENT key. This will turn ON the write function. Press
Enter and the second module should be copied. Repeat
this procedure to copy more modules.
After completing all copies:
- Insert original Memory Module
- Turn OFF AC power to the unit.
- Remove unit from enclosure
- Locate the copy switch and set it to OFF (red switch
labeled BP01)
- Put unit back in enclosure
- Put back insulator that covers the terminal block.
Make sure no terminals are exposed to the operator.
- Apply AC power to unit
- Insert the pin in the small pinhole (located in the
upper right hand corner) to rest the unit.
- Set the time and date.
CAUTION: DO NOT REMOVE MEMORY MODULE
WHILE UNIT IS AC T I V E . THE UNIT MUST BE
RESET; TIME AND DATE MUST BE RE-ENTERED
TO MAKE SCHEDULE SETTINGS EFFECTIVE ON
THE MEMORY MODULE.
NOTE: AFTER MAKING ANY CHANGES TO THE
PROGRAM, PRESS MODE TO GO TO RUN MODE
AND THEN PRESS EVENT TO UPDATE THE LOAD
STATUS.
14
Page 9

INSTRUCTIONS FOR SETTING THE UNIT

Connect unit to main power source prior to entering the
settings. When powering up the unit for the first time,
allow 1-2 minutes for supercap to charge and the display
will show 12 HOUR.
Press HOUR to change to 24 hour (military format) or
Press ENTER to set 12 hour (AM/PM format).
NOTES:
1. During the RUN mode, the Hour, Minutes, Seconds,
Day of week and flashing colons will be displayed.
2. The unit will not go into run mode unless the clock
and date is set. In any other mode, if no entries are
made for 5 minutes, the unit will automatically go to
the run mode.
3. Unit will display "PF" (Power Failure) in the absence
of AC power. A minimum of 8 hours is required to
fully charge the super cap.
4. When previously programmed unit comes back from
a power failure, it will "look back" and update the
schedule, executing the last scheduled event. If a
signal setting was scheduled, after power failure the
unit will execute the last scheduled signal. Settings
can be manually updated by pressing the EVENT
key in the run mode.
After pressing ENTER the unit will display:
NOTE: AFTER MAKING ANY CHANGES TO THE
PROGRAM, PRESS MODE TO GO TO RUN MODE
AND THEN PRESS EVENT TO UPDATE THE LOAD
STATUS.
3