Finish The Model - GREAT PLANES Mini Slinger Instruction Manual

❏
4. With a sharp hobby knife, cut a 3 mm [1/8"] deep slit
on the underside of the wing from this hole to the end of the
wing parallel with the leading edge.
❏
5. Feed the receiver antenna through the hole and
embed it in the slit. Cover the slit with transparent tape.

Finish the Model

❏
1. Use (4) #2 x 5/16" [8 mm] screws to attach the wing tips
to the wing.
❏
2. Press the propeller onto the motor shaft. The two
indentations at the center of the prop should face the model.
❏
3. Use the included hook and loop material to secure the
battery pack, receiver, and ESC to the radio tray. You can
also use optional double-sided servo tape. If using an
auxiliary elevon mixer, place it into the tray at this time and
check control surface operation with your radio. Computer
radio systems equipped with an elevon function will not
require a separate mixer to be installed.
8