Belt Clip & Headset - AT&T AT3101 User Manual

Getting started
Belt clip & optional headset
Install belt clip as shown below if desired:
Installation
Snap belt clip
into notches
on both sides
of handset.
For hands-free telephone conversations, use any industry
standard 2.5mm headset (purchased separately). For best results,
use a AT&T 2.5mm headset.
NOTE: If the sound
quality of the headset
is not satisfactory,
try unplugging it, and
firmly plugging it in
again.
Plug the 2.5 mm headset
into the jack on the side
of the handset (beneath
the small rubber flap).
7
Removal
Pull and unlock
one flap from the
notch first before
detaching the
whole belt clip from
handset.
HANDSET 1