Installing Advanced System Management Device Drivers; Installing Windows 2000 Asm Device Drivers - IBM eserver xSeries 440 User Manual

Authentication Protocol
The default is CHAP then PAP. Make sure that the value in this field
matches your client settings.
For detailed information about the PPP settings, see the information about
configuring PPP access over a serial port in the Remote Supervisor Adapter
User's Guide on the IBM Documentation CD.
6. Press F6 to apply the changes.
7. Press Esc. After the Warning window opens, press Enter to restart the Remote
Supervisor Adapter.
8. Press Esc to return to the Configuration Settings window.
If you need to configure the serial port, go to "Configuring the serial port for text-
based remote access:" on page 32.
9. Press Esc to return to the Utility program main window.
10. Use the arrow keys to select Exit Utility from the menu or press Esc to close the
Utility program.
11. Remove the diskette from the diskette drive. The server restarts automatically.
12. Continue with "Installing Advanced System Management device drivers:".
Installing Advanced System Management device drivers: You must install the
ASM device drivers for the server. The device drivers enable communication between
the Remote Supervisor Adapter and the server in which it is installed. You can obtain
the most current device drivers from the World Wide Web at
http://www.ibm.com/pc/support/.
The following sections describe the procedure for installing the ASM device drivers for
the server, depending on your operating system.
Notes:
1. If you are installing device drivers manually, note the following requirements:
• Make sure that the operating system is installed on the server before you
install the ASM device drivers. For information about installing the operating
system, see the documentation that comes with the operating system.
• Before installing the ASM device drivers for the Remote Supervisor Adapter,
stop any system-management application.
2. If you are using ServerGuide to install device drivers and your operating system is
either Microsoft Windows NT or Windows 2000, ServerGuide installs the ASM
device drivers automatically.
• Windows 2000: Continue with "Installing Windows 2000 ASM device drivers:"
• Windows NT: Go to "Installing Windows NT ASM device drivers:" on page 36.
After you install the ASM device drivers, go to "Configuring the remote control
password:" on page 37 to set the remote control password.

Installing Windows 2000 ASM device drivers:

Windows 2000, complete the following steps.
Notes:
1. Do not use the Hardware Wizard to install the drivers. If the Hardware Wizard
starts itself for the installation of any System Management Driver hardware, exit
the Hardware Wizard by selecting Cancel.
®
2. If IBM Netfinity Director, IBM Director, or UM Services is running on the server,
stop the system-management application before proceeding.
To install the ASM device drivers for
Chapter 2. Configuring your server
35