Configuring The Serial Port For Text-Based Remote Access - IBM eserver xSeries 440 User Manual

6. Change the DHCP Setting field to Disabled. The default value is Enabled.
7. Press F6 to apply the change.
8. Press Esc. After the Warning window opens, press Enter to restart the Remote
9. Press Esc to return to the Configuration Settings window.
10. Press Esc to return to the Utility program main window.
11. Use the arrow keys to select Exit Utility from the menu or press Esc to close the
12. Remove the diskette from the server. The server restarts automatically.
13. If you also want to configure the serial port, continue with "Configuring the serial
Configuring the serial port for text-based remote access: Complete the following
steps to configure the Remote Supervisor Adapter serial port for access using a
modem or null modem. If you completed the procedure for configuring the Ethernet
port and the Configuration Settings window is open, go to step 4
1. With the server turned off, insert the diskette with the downloaded utility program
2. The utility starts automatically, displaying the Remote Supervisor Utility window.
3. Use the Up Arrow and Down Arrow keys (↑ and ↓) to select Configuration
4. Use the arrow keys to select Modem Settings; then, press Enter.
5. Verify the following serial port values:
32
xSeries 440:User's Guide
For detailed information about the Ethernet settings, see the Remote Supervisor
Adapter User's Guide on the IBM Documentation CD.
Supervisor Adapter.
If you need to configure the serial port, go to "Configuring the serial port for text-
based remote access:".
Utility program.
port for text-based remote access:". Otherwise, go to "Installing Advanced
System Management device drivers:" on page 35.
into the diskette drive; then, turn on the server.
Settings; then, press Enter.
The Configuration Settings window opens.
The Modem Settings window opens, as shown in the following illustration.
Note: The values in the window are only examples; your settings might be
different.