Installing Windows Nt Asm Device Drivers; Using The Non-Interactive Method - IBM eserver xSeries 440 User Manual

Complete the following steps to manually install the Windows 2000 ASM device
drivers.
1. Open a command prompt.
2. If you are installing from a diskette, type: A:\WIN2000\SETUP, where A is the drive
3. If you are installing from a CD, type: D:\DD\WIN2000\SETUP, where D is the drive
4. Follow the directions that display on the screen.
5. Go to "Configuring the remote control password:" on page 37.
Installing Windows NT ASM device drivers: Choose one of the following methods to
install the ASM device drivers for Windows NT:
•
•
Note: If IBM Netfinity Director, IBM Director, UM Services, or IBM Netfinity Manager
Using the non-interactive method: Complete the following steps to use the non-
interactive method.
1. Open a Windows NT command prompt; then, type one of the following
2. Follow the instructions that appear in the window.
3. Go to "Configuring the remote control password:" on page 37.
36
xSeries 440:User's Guide
letter of the diskette drive.
letter of the CD-ROM drive.
Non-interactive
The non-interactive method for installing the ASM device drivers accepts the
default values for any window prompts that appear. You are prompted to respond
only if an error occurs during installation.
Interactive
The normal (interactive) method for installing the ASM device drivers prompts you
with instructions and waits for you to respond before continuing with the
installation.
is running on the server, stop the system-management application before
proceeding.
commands:
• If the installation is from a diskette, type:
A:\NT\SETUP -q
(where A is the drive letter assigned to the diskette drive).
Press Enter.
• If the installation is from a CD, type:
D:\DD\NT\SETUP -q
(where D is the drive letter assigned to the CD-ROM drive).
Press Enter.