Commands Details - Infinite Peripherals PP-50 Developer's Manual

. .
. .
. .
. .

Commands Details

.
HT
Horizontal Tab Command (HT)
[Code] [09h]
[Outline] Shifts the printing position to the next horizontal tab. The horizontal tab position is
set by ESC D.
The default tab setting is at each 8 characters (9, 17, 25 etc.) of font "A".
LF
Paper Feed Command (LF)
[Code] [0Ah]
Prints data from the buffer and feeds paper to the set line pitch.
CR
Print Line command
[Code] [0Dh]
This command is ignored.
ESC SP
Sets the space between the characters
[Code] [1Bh] + [20h] + [n]
[0 <= n <= 20h]
The entered data is binary. The distance between the characters is measured in dots
(1/203 inches).
The initial value is n=0. When the width of characters is doubled, the distance
between them is relatively doubled too.
ESC $
Setts the Absolute Position for print
[Code] [1Bh] + [24h] + n1 + n2
0 <= ? n 1 <= ? F F
0 <= ? n 2 <= 0? 1
The shift is n1 + 256*n2 dots. After the end of the line no positions are
acceptable.
Infinite Peripherals, Inc.
www.ipcprint.com
Version 2.00
Horizontal shift in dots (LS byte)
Horizontal shift in dots (MS byte)
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Page 15