Canon EOS DIGITAL REBEL XTI Service Manual page 120

4) Remova I of the ASD PCB Ass'y and ASM FPC
(l)Remove the FPC, connector, and connector with
lead wire from the back of the PCB (inside) at
one position each (Disassemble
if necessary).
(2)Remove two screws and the ASD PCB Ass'y.
5) Remova I of the MD PCB Ass'y
(l)Remove the lead wire with connector.
(2)Unsolder the three lead wires (green /black/
red).
(3)Remove the flex connector at two positions.
(4)Remove two screws and the MD PCB Ass'y.
<
Reassembly Cautions>
1 ) The MD PCB Ass'y
Check whether the shielding tape is attached at
the back of the MD PCB (inside) as shown in Fig.
097.
Repair Information
Fig. 095
Fig. 096
Fig.097
R\IW•UI 2I
There is a contact for date reset at the back of the MD PCB, so be
careful not to bend the PCB and make sure that it is not bent when
assembling.
29