Canon EOS DIGITAL REBEL XTI Service Manual page 115

6) Remova I of the CMOS Sensor Ass'y
(l)Remove two screws of shield and three
screws of the back.
(2)Remove the lead wire connector at one
position to the ASM PCB.
(3)Remove the CMOS Sensor Ass'y, making
sure not to damage it.
(4)Screw three Flange Back washers to the
original positions temporally, so as not to
lose them.
Repair Information
Fig. 079
r---------------------------------------------------------,
I I
1
R\IU@I 2I ·
Wear an antistatic strap when removing the CMOS Sensor Ass'y and
1
I I
keep it in the place where countermeasure against static electricity
1
are in effect. :
• Be careful not to damage or stain the removed CMOS Sensor Ass'y :
and handle it so as not to deform the exterior plate. :
7 ) Removal of the Interface PCB Ass'y (Disassemble if necessary)
Remove two screws and lift the Interface
PCB Ass'y to remove it.
24
Fig. 080
••
•. a
0
...