Canon EOS DIGITAL REBEL XTI Service Manual page 116

Repair Information
<
Reassembly Cautions>
1 ) The CMOS Sensor Ass'y
(l)Reassemble the CMOS sensor to match the reference point dowels to determine the
positioning, make sure that there is no dirt on the CMOS Sensor Ass'y, and decide the
position by avoiding the lead wire.
R\IW•UI 31
When the Main Base Plate Ass'y and lead wire touch, it causes
ActiveSweep operation malfunctions, so be careful not to pinch the
lead wire.
(2)Screw in the order shown in Fig. 081.
r - - - - - - - - - - - - - - - - - - - - - - - - - - - ,
I
R\IU @I
41
The length of screw
differs from EOS KISS
DIGITAL N, so use
screws of the correct
length.
2) The Main PCB Ass'y
(l)Check whether two pieces of insulating
tape are attached firmly in the positions
shown in Fig. 082.
(2)While being careful not to distort Part A
in Fig. 082, release the FPC and attach
four screws so that the PCB does not
move.
(3)Apply Bond 1663G to the two screws
shown in Fig. 083.
25
Fig. 081
Fig.082
Fig. 084
Fig.083