Canon EOS DIGITAL REBEL XTI Service Manual page 106

3) Reassembly of TFT display window
(l)Align the TFT light shield holder to the
right edge and attach it so that the clasps
fit into place properly.
(2)Peel off the backing sheet of the double-
sided tape for the TFT display window
and apply the tape according to the red
line as shown in Fig. 050.
(3)Hold the edge of the double-sided tape for
the TFT display window and remove the
covering sheet.
(4)Make sure that there is no dust on the
TFT, and then assemble the TFT display
window from the bottom side.
Repair Information
Fig. 049
Fig. 050
Fig. 051
R\IU@I 41
Be sure to apply the solvent properly. If too much solvent is applied
to the TFT display window, it will get dirty and its adhesiveness is
weakened.
~ ---------------------------------------------------------J
15