IBM eServer 200VL xSeries Installation Manual page 20

3. Rotate the foot inward to the unlocked position; then, remove the foot from the
4. Align the post in the center of the foot with the hole on the bottom of the server
5. Rotate the foot outward until the foot locks into place.
6. Complete steps 2 through 5 for each foot.
8
IBM xSeries 200 and xSeries 200VL: Installation Guide
server.
and place the foot between the guides as indicated.
Note: The following illustration shows the rear feet located on the bottom rear of
the server.
Feet (locked position)
Note: When you need to access the inside of the server to install options, you
might find it easier to lay the server on its side. If you do so, make sure the
feet are in the horizontal position (see the previous steps). Otherwise, the
feet might break off the server because of the weight of the server.
Guides
Guides