Running The Self-Test T - NEC Pinwriter P2000/P2X User Manual

RUNNING THE SELF-TEST
You tan use the built-in Pinwriter self-test to practice loading tut sheets and printing.
The self-test lets you check the printer's performante and print quality before you
connect it to your Computer.
Use A4-size Paper or 8 l/Z-inch wide Paper to practice loading and printing. In this
practice Session, you will print only a portion of the test. The Printer, however, will
continue to print the self-test as long as you insert paper-
To stop the self-test at any time, press MODE to stop printinp and turn off the power.
NOTE: When using continuous Papers, see Section 4, "Loading Continuous Papers" to
load Paper and then continue the following Steps from 8.
Set tbe Paper selection lever to the rear position.
Open the top cover and set the Paper thickness setting lever to Position 3 or 4.
Turn on the Printer power.
Make sure the carriage moves to the Center of the Printer and the lights are Off.
Close the top cover.
Slide the Paper guide so the @ie window is over the "A4" mark on the sheet
puide ruler.
Insert a sheet of Paper into the insertion slot of the sheet guide. The Printer
feeds the Paper to the Grst priot Position automatically.
Section 1 Start Here 5