Before installing the logs, you must fi rst remove the log shipping
bracket. Lift up to remove.
1. Remove the hearth strip / screen assembly and glass door. (Refer to manual).
2. Remove the andiron / grate assembly by removing the 2 screws located behind the andirons.
3. Remove the right log bracket, as shown. Note the position of the securing screw in the bracket.
4. Install the right, left and centre hearth bricks into the fi rebox, as illustrated. The hearth should appear seamless across
the front. Ensure that a ¼" space exists between the hearth bricks and the perimeter of the burner.
FIGURE 43-46
ANDIRON
ANDIRON
/ GRATE
/ GRATE
MOUNTING
MOUNTING
SCREW (
SCREW (
X X
5. Ensure that the tabs, located on the back wall of the fi rebox, have been bent forward horizontally.
6. Install the panels in the following order:
A - RIGHT
B - REAR
FINISHING
LOG SHIPPING BRACKET
DECORATIVE BRICK PANEL INSTALLATION
SECURING
SECURING
LOG
LOG
SCREW
SCREW
BRACKET
BRACKET
NG
NG
LP
LP
2) 2)
C - LEFT
D - BAFFLE
FIGURE 42
LOG SHIPPING
BRACKET
D
C
B
23
TAB
TAB
A
W415-0695 / 05.12.08