Inner Door Glass Removal - Viking VDSC530 Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
4. Remove side door brackets and door heat sink from
door skin.
5. Remove window holder and outer door glass from
door skin.
Note: The window holder is secured with double-sided
tape. Use care when removing from door skin.
6. Remove outer door glass from window holder.
Note: The outer door glass is secured with double-
sided tape. Use care when removing from
window holder.
7. Remove J mold from door skin.
8. Reverse procedure for installation.
©2009 Viking Preferred Service

Inner Door Glass Removal

Condition Requirements:
Outer Door Panel Assembly Removed
1. Remove four screws and door insulation retainer
from door glass bracket holders.
2. Remove three screws and door glass bracket holder
from inner door panel.
3. Remove inner door glass from inner door panel.
4. Remove black fi berglass rope from inner door panel.
Note: Use care with insulation, make sure to replace
any damaged or missing insulation. Keep vent
on inner door panel clear of insulation.
5. Reverse procedure for installation.
Disassembly
31