Disassembly; Access Control Board Assembly; Control Board Removal - Viking VDSC530 Service Manual

Disassembly

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Access Control Board Assembly

Condition Requirements:
None
1. Remove two screws and lift kick plate from keyhole
screws.
2. Remove two keyhole screws and lower access grill
from range.
3. Remove two screws and slide control panel assembly
from range.
Note: During installation, make sure the tabs on the
control panel are aligned with the slots on the
range.
4. Reverse procedure for installation.
28

Control Board Removal

Condition Requirements:
Control Board Accessed
1. Mark and disconnect all connectors from control
board and capacitors.
2. Place control board panel assembly on suitable work
surface.
3. Remove ten screws and control board from lower
mounting plate.
4. Reverse procedure for installation.
©2009 Viking Preferred Service