Access The Answering Machine Remotely - iDect eclipse 8035 Owner's Manual

11.7.1

Access the Answering Machine Remotely

1. Dial your phone number from any touch-tone phone.
2. When your answering machine answers your call and starts playing
your announcement, press the # key immediately.
• The announcement will stop playing.
3. Enter your Remote Access Code (same as your Master PIN code) within 8
seconds using the numeric keypad on the touch-tone phone.
Note that the answering machine will drop the call if you do not
enter the Master PIN within 8 seconds.
4. If the code is accepted, you will hear a confirmation tone.
5. The answering machine will start to playback all the messages on
your answering machine, beginning with new messages, or if there
are no recorded messages you will hear four beeps.
6. Use the keypad on the touch-tone phone to carry out the following
operations:
Keys
1
2
3
6
7
8
9
7. When you have finished listening to your messages, simply hang up
the phone to end.
Note:
If your answering machine is off but Remote Access is activated (See
on page 53 ), the answering machine will answer your call after 14 rings,
so that you can access it remotely, and the ANSWER ONLY
announcement will play.
If you enter an incorrect Remote Access Code, you will hear a triple-beep
error tone, and you will need to enter the code again. If you enter the
wrong Remote Code twice consecutively, the call will end automatically.
Repeat the previous message.
Playback messages / Repeat the current message.
Skip to the next message.
Delete the current message.
Turn on the answering machine in RECORD MSGS mode
(ECLIPSE Handset).
Stop message playback.
Turn off the answering machine.
60