Settings; Handset Registration; Register Eclipse Handset - iDect eclipse 8035 Owner's Manual

10

SETTINGS

10.1 Handset Registration

IMPORTANT: When you purchase your phone system, all handsets are
already pre-registered to your base, so you do not need to register them.
Handset registration is only necessary when you buy extra handsets or if
a handset has become faulty.
You can register up to four handsets to one base station, with each
handset's number (1 to 4) shown on its display.
Note: Each handset can only be registered to one base.
You need to enter the Master PIN before you can register or deregister
handsets. The default Master PIN is 0000.

10.2 Register ECLIPSE Handset

- For a ECLIPSE Type Handset
1. Press and hold the
• The message indicator on the base will flash for up to 1 minute,
while it is in registration mode.
2. On the handset, press
3. Press
4. Press
select.
5. Enter the Master PIN and then press
Note: After entering the Master PIN on either the ECLIPSE Handset,
• WAITING flashes on the screen.
• A confirmation tone is played to indicate successful registration,
and the handset returns to standby mode, with its handset number
displayed.
• If no base is found with the entered PIN, error tones are played to
indicate failed registration and PLS REG H/S is displayed on the
screen. You will need to repeat from step 1 above.
• During steps 2-5, if no key is pressed on the handset within 10
seconds, the registration procedure will be aborted. If this happens,
repeat from step 1 above.
key under the base unit for approximately 5 seconds.
.
/ to SETTINGS and then press
/ to REGISTRATION and then press
to confirm.
45
to select.
to