Operation Mode When Battery is Low
The printer acts differently depending on the remaining battery charge and the operation mode
when battery is low.
The printer has two modes and is initially set to the mode 1.
It is recommended to replace or charge the battery when the remaining battery charge
The remaining battery charge is detected before printing starts and the displayed
The operation mode when battery is low is selectable with the customized value. To set
The buzzer beeps five times when the remaining battery charge goes down to the levels
Mode 1
Battery LED
Level H
Level M
Level L
Level S
Level E
*: Printing may stop in the middle.
20
goes down to the level L.
amount is then updated. The Battery LED does not indicate the remaining battery
charge detected in real time.
the customized value, see
"Software Settings" on page
L or S. You can disable the buzzer with the memory switches. To set the memory
switches, see
"Software Settings" on page
Error LED
Approx. 60 100%
Approx. below 10%
44.
44.
: On
Remaining
Printing
battery charge
Possible
Approx. 20 60%
Possible
Approx. 10 20%
Possible
Possible*
Approx. 0%
Impossible
: Flash
: Off
Communication
Possible
Possible
Possible
Possible
Impossible