Wireless LAN Interface
If your printer is a Wi-Fi model, wireless LAN connection is available. Use EpsonNet Config,
which is a utility for wireless LAN settings by following the steps below.
Examine the radio wave situation in the surrounding area before use.
Avoid using the same channel that is used in the neighboring shops where wireless LAN
is used.
In the infrastructure mode, W53 and W56 channels are not available to connect to a
stealth SSID access point.
For detailed information about EpsonNet Config, see the EpsonNet Config manual
(operation guide) or the EpsonNet Config online help.
If you configure the wireless LAN setting without using EpsonNet Config, use the
network parameters printed on the dynamic status sheet. To print dynamic status sheet,
see
"Dynamic Status Sheet Print Mode (Only for Wi-Fi Models)" on page
The network parameters are initially set as follows:
Communication standard: 802.11b/g/n
Network mode: Infrastructure
SSID: EpsonNet
Security level: WPA-PSK (AES)
Passphrase: EpsonNet
IP Address: 192.168.192.168
Subnet mask: 255.255.255.0
To initialize the wireless LAN setting, see
Mode" on page
1
Connect the printer to a PC via the USB cable.
See
"USB Interface" on page
2
Turn on the printer.
3
Start up EpsonNet Config.
4
Double-click on the printer.
"Wireless Communication Setting Initializing
69.
37.
Chapter 2 Setup
71.
2
39