Optional Blower; Blower Instalation; Blower Operation - Pacific energy STEP D1 Installation And Operating Instructions Manual

Optional Blower

The optional blower kit (kit #WODC.BLOW) is equipped
with a three prong power cord and may be installed at
any time. Follow installation instructions supplied with the
kit. Route power supply cord away from heater.
Electrical rating: 115 volts A.C.-1.02 amps.
Fan output rating: 125 CFM
Blower Installation
1. Loosen the 2 screws at the center of the blower.
2. Install the temperature snap-switch assembly onto
the blower by placing the bracket over the screws.
(Fig.#5)
3. Tighten the screws.
4. Ensure that the two wires are connected to the
temperature snap-switch.
5. Slide the temperature snap-switch assembly up into
the space between the rear shield and the firebox,
ensuring that the temperature snap-switch contacts
the firebox.
6. Install the two screws through the flange of the blower
into the rear shield.
7. Plug the power supply cord in and check blower
operation.

Blower Operation

Proper blower speed matched with air control setting
will ensure peak performance from your stove. Operate
as follows:
- Air control set to low (right-most position), operate
blower speed control on "Low".
- Air control set between low and high, operate blower
speed control at desired setting.
Automatic: To operate the blower automatically, set the
rocker switch on the side of the fan housing to "Auto" and
set the speed control to desired setting. This will allow
the fan to turn on as the stove heats up to operating
temperature. It will also shut the blower off after the fire
has gone out and the unit cooled to below a useful heat
output range.
Manual: To manually operate the blower, set the rocker
switch to "Man" and set the speed control to desired
setting. This will bypass the temperature snap switch and
allow full control of the blower.
Switching from "Auto" to "Man" or selecting speed may
be done anytime.
12
FIG. #5
Temperature
FIG. #6
Switch
Power Cord
STEP.D1 090709-16