Connecting Bluetooth Devices; Disabling Bluetooth Devices - HP Z1 G2 User Manual

Hide thumbs Also See for Z1 G2:

Table of Contents

Connect the workstation to a grounded AC power outlet (1) and turn on the unit (2).

10.

Connect the unit to the Internet through the wireless feature or with an RJ-45 network cable.

To set up a WLAN and connect to the Internet, you need a broadband modem (either DSL or

cable) (purchased separately), high-speed Internet service purchased from an Internet service

provider, and a wireless router (purchased separately).

Connecting Bluetooth devices

The workstation is Bluetooth

Make your Bluetooth device send out a radio signal so that it is discoverable by the workstation

(refer to the device documentation for instructions).

In the Windows Control Panel, go to Hardware and Sound then to to Devices and Printers.

If your Bluetooth device is a printer, select Add a printer, select Add a network, wireless or

●

Bluetooth printer, and follow the on-screen instructions.

For all other devices, select Add a device, select Bluetooth devices, and then follow the on-

●

screen instructions.

The Bluetooth features can be disabled through the system BIOS, through the operating system, or

by removing the wireless modules from the system.

NOTE:

Disabling the Bluetooth features through the system BIOS or by removing the wireless

modules from the system will also disable the WLAN functionality.

To disable the Bluetooth features using the system BIOS, do the following:

-enabled. To connect a Bluetooth wireless device:

Setting up the workstation

Table of Contents