Network Bonding Combinations; Before Running Net Set Wizard - HP StoreOnce 2700 Installation And Configuration Manual

P3
P4
P5
P6
Bonding Modes Supported
1: Active Passive Bonding
4: Link Aggregate Control Protocol (LACP) Bonding
6: Active Load Balance Bonding
Command Successful
NOTE: The physical layout of 1 Gbit ethernet is reflected in the |link n| positioning of the
output. Looking at the rear of the HP StoreOnce appliance:
eth3 = LAN port 4 (P4), eth2 = LAN port 3 (P3), eth1 = LAN port 2 (P2), eth0 = LAN port 1
(P1)
eth4 (right) = P5 and eth5 (left) = P6 = 10 Gbit ethernet port on top card

Network bonding combinations

For single port connections, the Port Set contains just one port. However, for bonded connections,
a Port Set is a configuration of ports and bonding mode.
If you select a bonded configuration for your network, the StoreOnce CLI network wizard provides
a number of permutations for a Port Set, depending upon the availability and number of 1 Gbit
and 10 Gbit ethernet ports.
The example below is for an HP StoreOnce 2900, 4500 or 4700 Backup system, which has two
10 Gbit ethernet ports, and only one 10 Gbit ethernet bonding option.
Select bond configuration :
1 = eth0, eth1 (1 Gig) (default)
2 = eth0, eth2 (1 Gig)
3 = eth1, eth2 (1 Gig)
4 = eth0, eth1, eth2 (1 Gig)
5 = eth0, eth3 (1 Gig)
6 = eth1, eth3 (1 Gig)
7 = eth0, eth1, eth3 (1 Gig)
8 = eth2, eth3 (1 Gig)
9 = eth0, eth2, eth3 (1 Gig)
10 = eth1, eth2, eth3 (1 Gig)
11 = eth0, eth1, eth2, eth3 (1 Gig)
12 = eth4, eth5 (10 Gig)
IMPORTANT:
are no longer available for use in other Port Sets.
Each port set may contain one physical IPv4 subnet and one physical IPv6 subnet. However,
multiple virtual subnets (VLANs) may be attached to a single Port Set (up to a maximum of 128).
See VLAN guidelines (page

Before running net set wizard

NOTE: There is an alternative configuration wizard system set config that carries out a
number of additional configuration tasks, such as setting time, as well as running net set
wizard. Refer to
Backup system CLI Reference Guide for more information.
Before running net set wizard you must make a number of decisions about your network
configuration.
eth2 -
eth3 -
eth4 -
eth5 -
Once you have created a Port Set, the ports that you have defined for that Port Set
34).
Network configuration using system set config (page 28)
1 Gig
1 Gig
10 Gig
10 Gig
or the StoreOnce
Before running net set wizard 39